Phillip Schichtel
New member
I have a Phazer II. I am going to put a standard 121" track on it. However, I want to get a 1.5" lug, with this clear the tunnel or do I have to drill new supension holes to lower the supension ride height? thanks
98srx6
New member
Phillip, what conditions do you ride in?
Phillip Schichtel
New member
riding
I ride in the UP Michigan.....we do off trail riding... deep powder and hills
I ride in the UP Michigan.....we do off trail riding... deep powder and hills
98srx6
New member
I believe you can use a 1.5" track if you change over to small drivers on that sled. Not positive though, so you might want to take a look at the sled and measure how much room there is above the current track between the tunnel on top and in front of the skid.
Phillip Schichtel
New member
How much room is sufficiant between the top of the lug and the tunnel? Maybe a inch or so?
thanks
thanks
1.25" will fit with the stock 8 tooth drivers. Anything bigger will require 7 tooth. A 1.25" works real well on a phazer.
Snowextreme831
New member
Im with ryan. I put a 2" paddle on my sxr and only thing i did was changed the drives.
On that phazer I would go 1-1/4 and not change anything. gets costly for another 1/4". For the 1-1/2 and 7tooth drives you will loose some top end.
With my 2" paddle and smaller drives I still lost a little top end..but it ROCKS in powder.
Good luck Brent
On that phazer I would go 1-1/4 and not change anything. gets costly for another 1/4". For the 1-1/2 and 7tooth drives you will loose some top end.
With my 2" paddle and smaller drives I still lost a little top end..but it ROCKS in powder.
Good luck Brent