Advice installing pro action sx rear skid in 92 phazer ii

..SNAKEBIT..

VIP Member
Joined
May 2, 2003
Messages
1,055
Location
NE IOWA
OE rear skid is junk, broke & cracked all over.
have a 98 SX rear skid I am going to install
any body done this, looking for mount locations ans advice
 

It should not be too hard of a job.I would put both skids side by side with the adjusters backed right off then push them against a wall or straight edge.Then look were the front axles are located in both. Measure or use a template off the sx for the centre and rear if they are the same.
 
did a search not much luck, was hoping for someone that did it and had some pics,
and or measurements
 
923c3497e387e1404c38382e52d9d2fe.jpg
042527655a965e16ad276971f880ca54.jpg

Narrow the skid to fit the tunnel, moved the rear mount up and drill some holes,this is a sxr skid and it works really well


Sent from my iPhone using Tapatalk
 


Back
Top