Page 2 of 2 FirstFirst 12
Results 11 to 12 of 12

Thread: Stock 2001 SRX 700 primary - A fresh start

  1. #11
    Member Mini
    Join Date
    Feb 2015
    Location
    Ontario, Canada
    Posts
    54


    0 out of 1 members found this post helpful.

    Default

    Quote Originally Posted by mrviper700 View Post
    no, it wont work on a 97 sx, you don't have a long spring cap on clutch and the weight will be too heavy resulting in low rpm and poor performance. 8 dn20 weights from a 2000-02 srx will work good in a sx but youd have to use a lot lighter rivets as the weights are already heavier then stock. a longer spring cap from a srx will allow you to use the long springs as well. 51/43 helix works good in a sx. do you have any parts besides stock to work with?
    No I do not, All I have are the stock parts that are on the sled.

  2. #12
    Member Mini Wizard's Avatar
    Join Date
    Jan 2013
    Location
    Traverse City, Michigan
    Posts
    80


    Default

    Roller question: I already own a set of new 16mm. If I use them in place of the 15.6mm, would the .2mm (~.008") more from the center of the screw to the outside of the roller have a significant effect? I understand that the RPMs will be higher by comparison, but will it be much and what does it mean in the roller chart when it says "decrease force"?

Page 2 of 2 FirstFirst 12

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •