mikuni TM 36 x2

Vmax xtc 1997

Member
Joined
Jan 6, 2018
Messages
147
Location
Quebec
Hi

any carb specialist!!!! I am trying to find a rebuilt kit for my carbs on vmax 1997 2 cylinder. But all my search are inconclusive when I put the above title in the search engine and the carbs that come back form my search does not look exactly like mine ( probably because they have 20 years?) . I am looking for all the gaskets, o-ring and specifically the seals that goes on each side of the tiny needle bearings on each carbs.

Can any one point me in the could direction or website or the exact rebuilt kit number that would have all needed?

Thank you.
 

Not sure what you mean. No seals on the needle that I know of. Only the thin white plastic washers that sit at the top of the needles.
I would just replace the needle and seat assembly and the rubber o ring that goes around it.
Make sure ALL jets are clean, and your good to go.
 
Not sure what you mean. No seals on the needle that I know of. Only the thin white plastic washers that sit at the top of the needles.
I would just replace the needle and seat assembly and the rubber o ring that goes around it.
Make sure ALL jets are clean, and your good to go.

********************
might be my french accent :) that give me a hard time to properly explain my self. I will post a picture tonight.
 
carb 1.jpgcarb 2.jpgcarb 3.jpgcarb 4.jpg


In on picture I am holding the seal I am talking about, in the other with the red arrow this is the bearing I am referring to. thanks
 


Back
Top