I screwed up! Carb question.

MM700YZ125

New member
Joined
Jan 25, 2006
Messages
10
Age
41
Location
mn
Long story short...I was cleaning the carbs on my dads 2001 phazer mountain light, it had not been started in 8 years, EVERYTHING was gummed up and stuck! I ended up snapping off the "ear" that the float pin goes through. I tried to jb weld it but I must not have held as it is pumping fuel out of it so I can only assume the float is stuck down. My question is will the earlier phazer 2 carbs work on it? all I really need is the actual carb body I can swap everything else off my carbs. Thanks.
 

Same thing happened to me, drilled the post on both sides of the break with a tiny drill bit, put a small pin in it, and used a 2 part epoxy... That was in 1998, still working today!
 


Back
Top