s10mike
Member
I have installed 8 tooth drivers on my driveshaft and bought a challenger track with 2'' lugs. I want to know how much i have to cut off that 2''s to fit WITHOUT removing my front heat exchanger protectors? I think i would like to run at least an 1.5''lug, with possibly I-Grip screw in studs. Thanks guys
A couple of bucks
VIP Member
I don't think any?? It's going to be right there. If there is any .... overage, wear-in will take care of it. 97+ proaction I take it.
A couple of bucks
VIP Member
I've ran these and liked them ALOT. They are stupid easy to install.
http://www.bergstromskegs.com/tg/tg_main.htm
s10mike
Member
Yes sir, sxr/rx1hybrid 151 proaction skid. Seems everyone that I talk to that runs the i-grips loves them. The box of studs weighs 19lbs, box of I-Grips....2lbs. Thats big
s10mike
Member
Also, thanks for always lending a hand on here. Its appreciated
A couple of bucks
VIP Member
Thank-you.
That weight difference is substantial!!! Trying to remember...... I thiiink that for every six pounds of rotating mass, it takes 1 hp.
That weight difference is substantial!!! Trying to remember...... I thiiink that for every six pounds of rotating mass, it takes 1 hp.