Eben219
New member
My 700 is not running great, seems like it's running lean, high idle, bog when you crack the throttle and some backfiring. But when I crack the choke just a little it idles right down and runs great. I believe the jetting is stock. The carbs are clean and the fuel/ air screw is out 1.5, any ideas where to start?
RXMax
Member
Pull carbs again and check pilot circuit again. Sounds like pilots are still dirty.
Vincent
New member
X2
Mite be worth trying 1.75 turns on your fuel/ air screws
Mite be worth trying 1.75 turns on your fuel/ air screws
Eben219
New member
Ok thanks, I'll start with that. I did notice the first time I had them out the fuel/air screw was out 2.5 turns and that was the only thing I changed when cleaning the carbs. But I didn't floss the pilot jet holes either. just hit them with cleaner and air
hessracing
Member
I would pull the pilot jets out and make sure there clean!!
waterfowlah
New member
pilot jets are tuff. I use a jewelers loop on mine. if the opening (hole) is not perfectly round, its not clean