jjmoneysauce
Member
So on my 85/86 Enticers and 2011 Bravo, there are spare bullet connectors intended for heated grips. I'd like to use these to install a dash mounted RCA visor heater plug. I have a couple questions for you guys who may have done this before.
On the ET, there's 2 spare bullets in the steering column. The yellow/black wire comes straight from the magneto harness, and either the end in the steering column or the magneto harness tail should work, since it's not connected to anything else.
The black wire for the plug should be able to tie in in the other spare black wire bullet connector in the same place in the steering column, or to the other black wire spare bullet connector on the CDI box, as per the wiring diagram markup below. Correct?
My first question is, does polarity matter? The HJC helmets that I have are supposed to work with either AC or DC. I would by default hook the red wire of the plug to the yellow/black, and black to black.
The bravo power wire would be yellow/blue, and the ground any conveniently located black wire, correct? Same basic question, does polarity matter? Black to black? Also, I imagine that a 3A fuse would be a good plan?
On the ET, there's 2 spare bullets in the steering column. The yellow/black wire comes straight from the magneto harness, and either the end in the steering column or the magneto harness tail should work, since it's not connected to anything else.
The black wire for the plug should be able to tie in in the other spare black wire bullet connector in the same place in the steering column, or to the other black wire spare bullet connector on the CDI box, as per the wiring diagram markup below. Correct?
My first question is, does polarity matter? The HJC helmets that I have are supposed to work with either AC or DC. I would by default hook the red wire of the plug to the yellow/black, and black to black.
The bravo power wire would be yellow/blue, and the ground any conveniently located black wire, correct? Same basic question, does polarity matter? Black to black? Also, I imagine that a 3A fuse would be a good plan?
Last edited:
