Ultimax 3 Belt Alignment?

[SledBoy]

I'm installing an Ultimax 3 Belt (138-4432U3) on a 3xpiped viper instead of stock. The Ulitimax 3 is 1/4" longer than the stock belt. What do I need to do to ensure belt Alignment? I do have SRX engine torque adjusted installed, but know nothing about adjusting belt Alignment.

 

[yamaholic22]

just put more washers on the three deflection adjuster bolts on the back of the secondary, or take the bolts out completely if you have your center to center adjusted to spec. That should pick up the difference. If that is too tight, you can always remove a washer from the bolts.