Monkey_Throttle
New member
- Joined
- Dec 30, 2021
- Messages
- 11
Greetings!
97 VMAX xt 500
I recently rebuilt my water pump and replaced both bearings, the one in the water pump and the one for the oil pump. Along with all the seals the kit came with and a new belt.
The water pump belt tension was noticable tighter but with in spec of my manual, best I could tell.
But it's still dripping out of the weep hole!
Maybe I didn't tight down the turbine bolt enough, or maybe it's to tight? Any suggestions?
Cheers!
97 VMAX xt 500
I recently rebuilt my water pump and replaced both bearings, the one in the water pump and the one for the oil pump. Along with all the seals the kit came with and a new belt.
The water pump belt tension was noticable tighter but with in spec of my manual, best I could tell.
But it's still dripping out of the weep hole!
Maybe I didn't tight down the turbine bolt enough, or maybe it's to tight? Any suggestions?
Cheers!
Last edited: