REVREND
New member
- Joined
- Nov 11, 2004
- Messages
- 3
Hey Guys, I am working on my 1999 500 Vmax sx Twin.
I need to know what height to set the Throttle Slide Height at.
This is the first time anyone has ever opened up these carbs. I found that the two carbs aren't synchonized. I could actually see the difference in the two heights. The float heights were way out of wack too.
Cheers!
I need to know what height to set the Throttle Slide Height at.
This is the first time anyone has ever opened up these carbs. I found that the two carbs aren't synchonized. I could actually see the difference in the two heights. The float heights were way out of wack too.
Cheers!
REVREND
New member
- Joined
- Nov 11, 2004
- Messages
- 3
Drill bit?
I was told to use a drill bit to measure the amount that the slide is open. I am just wondering what size drill bit to use??
I was told to use a drill bit to measure the amount that the slide is open. I am just wondering what size drill bit to use??
yamaholic22
Active member
the center one is the master, you want the other ones set the same as the center on the triples