n2oiroc
New member
what should i run for carbides, 8" or 10"? 02 viper 136" x 1.25" 6 pitch with 108 studs down the middle. 05 mountain skis up front. thanks
yamaholic22
Active member
its all a matter of preference, honestly. I would run 10", i like being able to turn
Carbide
I am currently running my 136" Viper with 7" C@A Pros with Bergstrom 24" (3x8") bars. With my limiter straps set with 1/2" above the bracket and these ski's and bars I have handling as good as the stock 121" ever was. I was at the last TY ride in Muni and could run the twisties right with the 05 RX1's that ran at the front both days. You can ask Ding if my sled was handlin' Ok, he was behind me for a while. He is running the Mountain ski's on his Viper, so youmight ask him about his setup. Hope this helps you out.
Dave
I am currently running my 136" Viper with 7" C@A Pros with Bergstrom 24" (3x8") bars. With my limiter straps set with 1/2" above the bracket and these ski's and bars I have handling as good as the stock 121" ever was. I was at the last TY ride in Muni and could run the twisties right with the 05 RX1's that ran at the front both days. You can ask Ding if my sled was handlin' Ok, he was behind me for a while. He is running the Mountain ski's on his Viper, so youmight ask him about his setup. Hope this helps you out.
Dave
I would look into Saber's Shaper Bars. I used them on my 136" SRX with 162(I think) studs in it. Worked real well, and I could keep the limiters out alittle for better transfer but still have full control in the corners.