nailsandrails
VIP Member
I was working on getting a 48-36 helix dialed in last year with heelclickers on a 00 ported SRX. It was not my machine, but it just kept falling off on top end. Valves were clean, but finally after the last trip found out the cables were crossed at the servo motor and not letting the other valves open up all the way. I have now came accross a bender 9860 helix. Should be a 51-45 from reading on this site. Since I will be starting over next year anyway, I was wondering what helix you guys think I should use?
yamaholic22
Active member
with the clickers go with the 48/36. The other one is too much finish angle for the clickers and top end will suck