yamyrider
Active member
Posted this in Work forum but did not get much response.
Guys before I start work on my 2000 SXR7 I would like a review of what I am thinking.
I have been reading and learing a little about clutching and set up.
Am I in the ball park or out to lunch...
AAen triples, 150 mains across, 8dn10 empty to start(already have these), GWG primary, G sec with 49/45 Bender helix at 70.
I will fine tune for about 9000 rpm. Am I just or is this a decent set up for aggresive trail and lots of lake crossing. I can change springs if there are better ones to use.
I will also check my reeds and if they need replacing will go with carbon tech reeds.
Thanks.
Guys before I start work on my 2000 SXR7 I would like a review of what I am thinking.
I have been reading and learing a little about clutching and set up.
Am I in the ball park or out to lunch...
AAen triples, 150 mains across, 8dn10 empty to start(already have these), GWG primary, G sec with 49/45 Bender helix at 70.
I will fine tune for about 9000 rpm. Am I just or is this a decent set up for aggresive trail and lots of lake crossing. I can change springs if there are better ones to use.
I will also check my reeds and if they need replacing will go with carbon tech reeds.
Thanks.