ridesrx
New member
of the W-arm with the bump stops in it? I took mine out to reinforce it a while ago, and now I can't remember which way they go. I think it is the rounder side of it that should come in contact with rail right? Thanks guys.
The round side goes up, and the pointed side comes down to make contack with the stopper on the rail. I think I have a picture from my post of my sled for sale.
1CS
1CS
SRX MAINE
VIP Member
Here's Max Perf. HD one. The pointed side looks to go up towards the limiter strap loop side
Hope this helps
Hope this helps
Last edited:
WHAT? ME WRONG???? lol. Maybe I put mine in backwards! Sounds like me, always A*S backwards. lol Sorry about that, man. It just made scence to me to put them in that way.
1CS
1CS
yamaholic22
Active member
that's what i thought too, but i wasn't positive because i haven't seen one in a week, lol
I've figured it out.....Max must be backwards because I am never wrong. lol
1CS
1CS
SRX MAINE
VIP Member
Crazysledder, That's pretty funny.
My W arm is away being welded and I was 2nd guessing myself too after reading this post
How about this.
I think the bottom of bumper (#2) is suppost to hit plate (#29)
& the top pointed side of the bumper (#2) hits the bottom of shaft (#36)
And if it hits these points, one too many times, then you end up with a two piece W arm..... LOL
My W arm is away being welded and I was 2nd guessing myself too after reading this post
How about this.
I think the bottom of bumper (#2) is suppost to hit plate (#29)
& the top pointed side of the bumper (#2) hits the bottom of shaft (#36)
And if it hits these points, one too many times, then you end up with a two piece W arm..... LOL