..SNAKEBIT..
VIP Member
installing Atacc on my 02 Viper CPR pipes & head opticool gasket
where do you think I should start?
where do you think I should start?
skidooboy
New member
with what? installation, jetting, clutching???? ski
i would he is talkin about jetting if he is saying he is installing a attack ski, talk to jeff ,but then he will telll you to talk to holtz.i did the same to the one i sold my buddy, never ran it yet with the attac on it but its going to what jeffs starting point is, never had a isssue with it there at minus 35 c, and it was way rich when it warmed up, 47.5-47.5-50 pilots, all clips in 4th position with 2 washers above clip on pto and mid, washers under on mag. 160-160-162.5, i have adjustable pilot scew adjusteres so i juist adjust it as i need to, head mod is done
..SNAKEBIT..
VIP Member
SORRY guys yea I am talking jetting
But I also have a set of 8dn-10 going in the clutch any suggestions for a good starting point, have helix 50/40, and stk 47. green & red spring, also I think 43 & 44/40 can try?
rode it from dead stop pulls @ 8200-8400 feels sluggish very slow to 9000
rolling @ 20mph goes to 9100 pulls to 9300 feels alot stronger
any suggestion what to do?
But I also have a set of 8dn-10 going in the clutch any suggestions for a good starting point, have helix 50/40, and stk 47. green & red spring, also I think 43 & 44/40 can try?
rode it from dead stop pulls @ 8200-8400 feels sluggish very slow to 9000
rolling @ 20mph goes to 9100 pulls to 9300 feels alot stronger
any suggestion what to do?
Last edited: