Ripsaw 1.25 on 01 SRX??

[airtimerascal]

I am trying to replace a stock track on my SRX with a Ripsaw 1.25". There is not enough room between the front drive shaft and heat exchanger with the 9 tooth drivers. Do I need to go to a set of 8 tooth drivers?? Helphttp://www.totallyamaha.net/forums/newthread.php?do=newthread&f=66#
This Site Rocks

 

[FLYBYU]

you'll have to go to 8 tooth drivers. i'm in the works for putting the new 1.5 in mine 01 srx

 

[98srx6]

You can fit a 1.25" track on your srx no problem unless you are looking to stud.

 

[BLUEBY]

Granted i have not played with any settings on the rear suspension yet but good luck keeping the skis on the ground!! Hookup is unbelievable.