RE: look at my piston wash and tell me what you think

I would say your pto is rich center a little rich and I can't tell on the mag but that is probably rich also.
 
That's wha I was hoping, I wanted to jet a little rich at first, now I can lean out, but another question, is this piston wash general or is it like just for main's or pilots? or all????
 
You must check each circuit in the carbs individualy what I am saying is ride your sled with the throttle from idle to 1\4 this is your pilot jet for about a mile or two then kill the motor leaving the throttle in the same position pull your plugs and with a bend a light you can check your wash then repeat the same process with your throttle in the 1\4 to 2\3 open this is your needle jet then repeat the same process with it wide open this is your main jet you need to have about a 1\4" to a 1\2" wash on your pistons the bigger the wash the fatter you are jetted I run a 1\4" wash on my Viper and it runs great also don't forget to do it when it is cold because if you jet on a warm day you will run lean or burn down on a cold day.
 
You must log in or register to reply here.


Back
Top