hc 40-10 need help ! (VIPER)

[quebec#1]

I have hc 40 -10s kit that hasnt been installed yet. I will get a dalton helix 50/40 but i want a consistent 8600 rpm's and dont want to drop my rpm's any lower any recomendations ? Should i stay with the stock secondary and put the hc red in the primary ? The machine is stock it has 96 studs on the yoko track, the machine is a 2002 with 1100 miles. I weight about 175 pounds. I want better take off and good mid range and i dont want to sacrafice my top end speed.
I could use some help here before i go out and buy a new helix that might not be for me.
Thanks

 

[mrviper700]

try a 4.0 in the heel, 3.3 in the middle hole, 4.3 in the tip, use a 48/34 helix with a red spring@90, this runs strong in a single piped viper.

 

[quebec#1]

What brand of helix should i get ? (48/34)

 

[mrviper700]

helix

dalton or a maxx perf.

 

[kirkswim]

3.0g in the heal 4 in the tip red spring, 48/40 adavant edge helix at 70 with stock spring 8500 night and day -5c to -40c with stock exhaust


props to turk for clutch setup