n2oiroc
New member
136" x 1.75" viper, stock motor, torque stop, 8 tooth drivers, 22/38 gears, 48/40 advant helix and green secondary spring wrapped at 70*. primary is stock. seems a bit sluggish, runs about 8,300 out of the hole and creeps to 8,500 - 8,700 after 50 -60 mph depending on the mood. any suggestions? thanks!
yamaholic22
Active member
You are probably finding that it acts sluggish with the longer track because the stock 8EK weights dont have much profile to them. A set of 8DN-20's with almost that same setup will perform a lot better, offtrail as well as on.
n2oiroc
New member
do you have a spare set laying around?yamaholic22 said:
yamaholic22
Active member
no i dont bro, sorry. I do have some dalton dpy-53's that are similar in profile but don't have any adjustablity (just like polaris weights)
n2oiroc
New member
thanks anyways. ill try and find a used set. how much $ do they usually go for?yamaholic22 said:
yamaholic22
Active member
i would say usually around $30-40 shipped used. You could always bring that baby out to the lake to get her dialed in once you get your weights and some rivets
n2oiroc
New member
will do. when is it frozen good?yamaholic22 said:
yamaholic22
Active member
i was out there last weekend there was a solid 6", and its been plenty cold since then. There have been a lot of sleds out there. I'll let you know how it looks thursday when i get home, i'll go out and take some measurements.
n2oiroc
New member
i need good solid ice, i cant swim! lol!yamaholic22 said:
yamaholic22
Active member
lol yea my dad can't either. I'll let you know the conditions on thursday, but i would bet there is at least 8 or 9" now. I'll be out there tuning a buddy's ZL 500 (that's right boys, laugh it up, I'M going to tuning an artic cat) lol