Can anyone provide a photo or some detail on the best tool to trim the lugs that are rubbing on my heat exchanger protectors? I just don't know where to buy one.
Thanks
Thanks
redsnake3
New member
carpenters knife 
Tried that. Lugs were to soft. Kind of a pain in the a$$.
Millinocket Rocket
New member
this is the tool i used- worked great and is the same width as the clip window
http://buy1.snapon.com/catalog/item...group_ID=11631&store=snapon-store&dir=catalog
http://buy1.snapon.com/catalog/item...group_ID=11631&store=snapon-store&dir=catalog
Thanks MR.
Any idea where I can buy these locally?
Any idea where I can buy these locally?
940ken
Member
SEARS or any hardware less 10.00 and they work great!! 
Waterfoul
New member
That's what I had in mind for this kind of job too... glad I don't have to do it though!
Just tried the tool MR recommends. Works perfect! No mess like a razor or knife.
yamaholic22
Active member
I haven't found them for less than like $16 dollars anywhere.
yamaholic22 said:
Sounds about right. $14.99 + tax at my local Aubuchon Hardware.
http://hand-tools.hardwarestore.com...rwin-vise-grip-end-cutting-pliers-113880.aspx
