firemrshllbill
New member
I have an 03 Viper w/o electric start. I have the plug in for the electric face shield by my hand warmers, but the is a black and a red wires, for my shield, are not connected to anything. The black is the ground and it has a loop on the end so im guessin that gets grounded out on the handle bar bolt. Where does the red wire go to?
Jerry
Jerry
extremeviper
Member
Red wire to 12 volts, use the brake light curcuit and ground to the bolt that holds the air box down
firemrshllbill
New member
Do I connect it by the brake lever and what color is the brake light wire?
Thanks
Thanks
extremeviper
Member
Sorry tail light not break light curcuit must be a constant 12v, not sure of the color of the wire.
heated visor
It's the blue wire, this is the load ( hot/live ) wire to the brakes and I ground it out to one of the handle bar bolts, have over 16,000 km without a problem...but mine is non-electric ( batteryless type )...Why don't you just wire it to the battery, in your kit with the helmet the wire is long enough to go to the battery...good luck...
It's the blue wire, this is the load ( hot/live ) wire to the brakes and I ground it out to one of the handle bar bolts, have over 16,000 km without a problem...but mine is non-electric ( batteryless type )...Why don't you just wire it to the battery, in your kit with the helmet the wire is long enough to go to the battery...good luck...
firemrshllbill
New member
Mine isnt electric start, I am guessing you can access the blue wire for the tail light right my the handle bars?