Skid Question

cacsrx1

cacsrx1

New member
Joined
May 18, 2004
Messages
429
Location
Highmore SD
Anybody know offhand is a skid from a 04 RX1 mountain will bolt into a SRX tunnel without too much trouble. Gonna longtrack this fall and Im exploring my options.
 

Tunnel widths are different. You may need to cut the shafts down to get the suspension arm width correct for it to slide in the tunnel. I have a RX-1 Mtn & Viper skid sitting here and can measure if you want me to.
 
Srxspec said:
Tunnel widths are different. You may need to cut the shafts down to get the suspension arm width correct for it to slide in the tunnel. I have a RX-1 Mtn & Viper skid sitting here and can measure if you want me to.
Click to expand...

Wana sell one. lol
 
RX-1 Mountain:
-Front Arm: 16.5"
-Mid Mount: 15.375"
-Rear Mount: 15"

Viper:
-Front Arm: 16.5"
-Mid Mount: 16.25"
-Rear Mount: 16.75"

If you want to buy a whole skid let me know!
 
If I remember right, when we put Clifford's RX-1 suspension in Jr's SRX we had to use the old upper rear shaft from the SRX suspension. Not sure if that applies to the RX Mountain suspension as well? It sounds like thats what Allen was talking about though.

Let me know if you want me to keep an eye out for skids or any other parts you need at Hayday's. Or you can just come with. ;)! I think my brother wants to go too but I doubt he'll be able to. So far it's just me and Jr. going for sure.
 
Last edited:
Not wanting to Hijack this thread (I am looking for a monoshock suspension for my SRX) if anyone is willing to sell one for a reasonable price.

Thanks
 
I will sell RX-1 rear skid for $200. It's from a 2004 RX-1 Mtn. You'd simply have to swap a few shafts & idlers and it would bolt into the extended SRX.
 
Srxspec said:
I will sell RX-1 rear skid for $200. It's from a 2004 RX-1 Mtn. You'd simply have to swap a few shafts & idlers and it would bolt into the extended SRX.
Click to expand...

Consider it sold. Ill PM U later.
 
You must log in or register to reply here.


Back
Top