i need to know step by step what i have to do to put my rx-1 suspension in my srx, and i have a chance to get a pro-x suspension is there a lot of work to put that in my srx please help






If it is an 03/04 RX skid it will bolt right up, if its an 05 Mono skid there are alot of guys around that did that swap and I am sure you will find hep here.D-HK45 said:i need to know step by step what i have to do to put my rx-1 suspension in my srx, and i have a chance to get a pro-x suspension is there a lot of work to put that in my srx please help![]()
![]()
![]()
![]()
![]()
shortstop20
New member
- Joined
- Mar 6, 2005
- Messages
- 1,583
- Age
- 38
- Location
- Stickney, South Dakota
- Website
- www.snowmobilefanatics.net
You will need to use the rear upper cross shaft from your SRX suspension in the RX-1 skid.
Here are the measurements for mountaing a Pro-X skid in a RX-1.
http://www.jbshocks.com/edgeswap/proxmount.jpg
Here are the measurements for mountaing a Pro-X skid in a RX-1.
http://www.jbshocks.com/edgeswap/proxmount.jpg
jr_amsoil
New member
what shortstop said did the same swap to my srx but got rid of the stock rear shock in the rx1 skid as it is not rebuildable.
Shaft
WHY DO I NEED TO CHANGE OUT THE UPPER SHAFT YAHAMAS ARE NEW TOO ME

WHY DO I NEED TO CHANGE OUT THE UPPER SHAFT YAHAMAS ARE NEW TOO ME




The tunnel must be slightly wider, mount points are the same.
shortstop20
New member
- Joined
- Mar 6, 2005
- Messages
- 1,583
- Age
- 38
- Location
- Stickney, South Dakota
- Website
- www.snowmobilefanatics.net
Yes, the SRX tunnel is wider. It only takes 5 minutes at most to swap the shafts.