FirstGenCTD
New member
Hi everyone, first post here.
I have a 433 engine I pulled from a wrecked yamaha my dad had in the yard(long gone now). It had the hydraulic drive, and from what i could tell it was maybe a 74 model? Anyway, I was wondering if there was any interest if I were to sell it. I know it runs, at least it ran right before i pulled it out of the sled.
thanks,
matt
I have a 433 engine I pulled from a wrecked yamaha my dad had in the yard(long gone now). It had the hydraulic drive, and from what i could tell it was maybe a 74 model? Anyway, I was wondering if there was any interest if I were to sell it. I know it runs, at least it ran right before i pulled it out of the sled.
thanks,
matt
did you happen to pull any other parts? I need the shift linkage for that year and model sled.
If you have just the motor you may want talk to Ronhydraulic here on T.Y. he is the "residant expert" on hydraulic sleds.
Mills
If you have just the motor you may want talk to Ronhydraulic here on T.Y. he is the "residant expert" on hydraulic sleds.
Mills
FirstGenCTD
New member
most of the sled was scraped when we cleaned out our yard a while back. I have the engine, and I might have some steering parts, but im not sure, i would have to look.
matt
matt
RON HYDRAULIC YAM
Member
Hi Matt ,,,,you are a "little" futher away than any road trip
I have done for a sled yet...Washington state??
....I'm in Ontario ,Ca...I've tried to forget the $850.00 in gas
that was spent in 2006 ...but "we" had a great time and
met some great Yamaha people in MI , WI , MN and MB.
The crank will have a almn cog drive on it to be used
with a 1/2" pitch timing belt..about 1.5" wide ....Sound
close ??? Usually the Hyd unit is around because it was
so unusual , people didn't have heart to toss them ..
The chassis rusted out under the seat and in the
double walled area under the engine .I have had a couple
that were only held together by the suspension and
track.
RON
I have done for a sled yet...Washington state??
....I'm in Ontario ,Ca...I've tried to forget the $850.00 in gas
that was spent in 2006 ...but "we" had a great time and
met some great Yamaha people in MI , WI , MN and MB.
The crank will have a almn cog drive on it to be used
with a 1/2" pitch timing belt..about 1.5" wide ....Sound
close ??? Usually the Hyd unit is around because it was
so unusual , people didn't have heart to toss them ..
The chassis rusted out under the seat and in the
double walled area under the engine .I have had a couple
that were only held together by the suspension and
track.
RON