jmp2204
Member
I amy have previously posted this in the wrong section
http://www.totallyamaha.net/forums/showthread.php?t=51712
Anybody know the tolerance on the bushing clearance on the primary (main shaft) and the secondary mainshaft (both sides) .I know aaens rule of thumb ,exerting force on one side it should still slide ,but does anyone know the #'s?
http://www.totallyamaha.net/forums/showthread.php?t=51712
Anybody know the tolerance on the bushing clearance on the primary (main shaft) and the secondary mainshaft (both sides) .I know aaens rule of thumb ,exerting force on one side it should still slide ,but does anyone know the #'s?
marinetech50
New member
what sled?
jmp2204
Member
sorry 02 srx (i'm thinking they should all be the same)
guardrail
New member
I don't know what the clearance is, but I measured a new primary and it was 41.30 mm. I have a secondary on order. I'm going through my clutches before the season starts.
It's a 90384-41242.
When I get my secondary i'll measure it.
hope this helps
It's a 90384-41242.
When I get my secondary i'll measure it.
hope this helps
jmp2204
Member
i'm looking at the wear on the bushings on all the shaftsguardrail said:I don't know what the clearance is, but I measured a new primary and it was 41.30 mm. I have a secondary on order. I'm going through my clutches before the season starts.
It's a 90384-41242.
When I get my secondary i'll measure it.
hope this helps