bufalobob
Member
anyone with motor mods would be well advised to go to dynotech's web site & read the 13 page test just done on a '09 polaris dragon 800. before someone chimes in & says "it's not a yamaha" --- forget it, it doesn't matter!! the core content of the material is generic & can be applied to most any 2 stroke. polaris flew in a engineer overnite due to problems jim & casey were experiencing w/ the 800. they removed the thermostat & brought the coolant temp down from 125* to 95* eliminating deto & allowing them to lean out the fuel system & increase power.
bob
bob
nailsandrails
VIP Member
You have to subscribe to read that article. 
mopar1rules
Active member
hey bob, could you post that article on here or send it to me? hows the new house/land treating ya?
bufalobob
Member
snowdust:
yes you do. $20. for 12 months. the biggest bang for the buck you will ever get. all the big guys use dynotech - d&d, bender, ulmer, htg, emery, hall, bikeman, schrader, chuckaroo, etc., etc. etc..
mopar:
the view is non stop. the pool is still open - 49*F - outside. spend the $20. lots of info in the archieves.
bob
yes you do. $20. for 12 months. the biggest bang for the buck you will ever get. all the big guys use dynotech - d&d, bender, ulmer, htg, emery, hall, bikeman, schrader, chuckaroo, etc., etc. etc..
mopar:
the view is non stop. the pool is still open - 49*F - outside. spend the $20. lots of info in the archieves.
bob
mopar1rules
Active member
might be something i'll have to look into further then.