SRX 700 Track Install ?

23outlaw

New member
Joined
Nov 13, 2008
Messages
23
Age
45
Location
Massena, NY
I just installed my track and I ran into a little problem. The track I put on is a camoplast hacksaw 1" track. Some of the lugs are rubbing on the front heat exchanger protectors. Should I clip those lugs or just let them wear down on there own. Every other set of lugs is the full width of track, where the stock one wasn't.

Awesome site!!!!
 
Take a good pair of side cutters and trim the little tabs in line with the heat exchangers like so:

You can see where i trimmed if you look close.
 

Attachments

  • FULL SD CARD 074 (b).jpg
    FULL SD CARD 074 (b).jpg
    250.5 KB · Views: 41
I thought there was room for a 1" lug on stock Yamaha's? I know my 1 1/4 lug hit, but I trimmed it down at the protectors like Roost'er.
 


Back
Top