NY AttakGT
VIP Member
There is a page in the tech section on adjusting P-valves (by KGMZ) but I believe it is out of a Viper (SXV700) service manual. Is it exactly the same cable routing in the servo on a 2001 SRX?
See pics 2 and 3 on this page.
http://www.totallyamaha.com/snowmobiles/aaTECH/YPVS/pv3.jpg
In the middle of the page, on right, it says
CABLE INSTALLATION POSITION
#1 Cable Lower Notch (1)
#2 Cable Upper Notch (2)
#3 Cable Center Notch (3)
I am assuming "#1 Cable" is coming from Cyclinder 1? "#2 Cable from Cyclinder 2? "#3 Cable" from Cyinder 3? Which notches (lower, upper, and center) are they talking about?
To the left of the servo pulley on the casing it is labled 1 at the top, 2 in the center, and 3 on the bottom (as seen middle pic on left). Are those the "notches"they are talking about?
--Steve (O.C.
See pics 2 and 3 on this page.
http://www.totallyamaha.com/snowmobiles/aaTECH/YPVS/pv3.jpg
In the middle of the page, on right, it says
CABLE INSTALLATION POSITION
#1 Cable Lower Notch (1)
#2 Cable Upper Notch (2)
#3 Cable Center Notch (3)
I am assuming "#1 Cable" is coming from Cyclinder 1? "#2 Cable from Cyclinder 2? "#3 Cable" from Cyinder 3? Which notches (lower, upper, and center) are they talking about?
To the left of the servo pulley on the casing it is labled 1 at the top, 2 in the center, and 3 on the bottom (as seen middle pic on left). Are those the "notches"they are talking about?
--Steve (O.C.
