Stevie Ray
New member
I was wondering about this Vmax I just picked up. It sure has a lot of high performance parts on it. The front end is 39.5 inches wide and has this sway bar mounted under the belly that connects the arms on both skis. I was going to part it out but if it's something rare I should maybe keep it together. I noticed the clyinders are ported and the rods are smoothed and polished. It also has exhaust temp gauges. I am no Vmax expert so any info would be great.
YAMMIEGOD3:16
Active member
THAT NOT A FACTORY BUILT RACE SLED. MY GUESS ITS A BENDER WIDING KIT. ALSO PROBLEY BENDER PORTED CLYs. THESE THINGS WERE OFFERED TO ANYBODY WITH A VMAX FROM BENDER RACING. 3:16 (yammie tony)
yamaha one
New member
Does it run I am in need of a complete bottom end
killerklown
Member
pictures?
Vmax540
VIP Member
Considering where you're from maybe it was set up by RPC ? Any aftermarket stickers ?
YamaChris
New member
A friend looked at a custom vmax years ago that looked pretty modded. It had a really low serial number and he always wondered what the story was. The widening kit looked pretty rough and had rubber pieces closing the gaps. I see you are in MN, thought it might be the same one. Any pics?
MR LAKE
New member
Post pics I had one lots of mods wide low and bender sway bar