been reading alot about updating the phazer carbs when installing a AAEN pipe. one post said to remove welch plug and drill midrange hole another said to replace primary nozzle and main nozzle. could the stock nozzles be redrilled or just drill the midrange hole after removing the welch plug. what are you guys thoughts. thanks...
PZ 1
Member
- Joined
- Mar 12, 2005
- Messages
- 987
Contact Aaen.
It is not an update on the carbs. It is needed for the right fuel mixture when using the pipe. If you go back to the stock exhaust, the carb will also have to be changed back.
It is not an update on the carbs. It is needed for the right fuel mixture when using the pipe. If you go back to the stock exhaust, the carb will also have to be changed back.
tedgoesfast
New member
any time i put a pipe on all ive ever done is set floats richer ive head no problems but i would contact aeen to be sure
phazer max
New member
what jetting install phazer 1992 porting d.g pipe
tmx 38 pilot and main - needle clip thanks
tmx 38 pilot and main - needle clip thanks
Yamaha Nutz
New member
phazer max said:
i would start out with the stock needle in the carbs set in middle clip with 45 pilots and 260 mains