Just as the title says...... My 2003 Mnt. Viper may be getting a newer track. It has the stock 144" X 2" tall lug Camo Challenger. Is their any options for 2 1/8 or 2 1/4" track? Will a taller track fit?
Thx,
Mike
Thx,
Mike
You will have to take out tunnel protectors and change to 8 tooth drivers, 2 1/4 is the largest I have seen on one, Doesnt mean you cant fit more though You would have to measure and see where the clearance is at.
yamahaboy701
New member
It should already have 8 tooth drivers on it. Tallest track I have seen on a stock mountain viper was 2 1/4 but the front heat exchanger did have a lot of black rub marks and bent fins. There was maybe 1/16 of an inch between the heat exchanger and the tallest lug on the track. (Should also mention it was a finger track) I would stick with 2" to allow plenty of room for the snow to flow.
Thanks everybody --- it looks like a new 2" Challenger then!!!
A K MtnViper
New member
I would put Aanti Ratchet drivers on while it is apart. Looser track equals more HP to snow and less Hy-Fax wear.
mod-it
Member
Good advice from AK, might as well get some FREE HP to the ground.
cacsrx1
New member
EVERY sled should have anti-ratchets on it. Imo its one of the most overlooked performance gains.
Fro
New member
Do you need fully clipped if you run anti-ratchets?
no, just every window has to be open.
You can drop and roll if you want to go taller.
Ding- do you know anyone still making the templates and chaincase kits for the drop and roll?Ding said:
It has been a year or 2 but I was considering doing it to a Viper Mtn. There were a few responses on Snowest.com from guys that either had parts already or had the templates to make them. I would search there first. If you don't find anything, PM me and I will look for my old messages about this and get you some names.
One guy off the top of my head that would know is Tom Hartman.
One guy off the top of my head that would know is Tom Hartman.