Piped Viper Clutch Setup Help...

[YrkViper]

I am looking for some help with the clutching for my Viper.

I've spent the past few nights reading the forum and going through the clutching setups on the tech pages.

I have a Bender 52/40 helix and an Dalton ( IIRC) 50/40 helix.

I will be running Bender pipes and heelclickers along with ported heads, 8T Extroverts 144" track, and 23/38 gearing.

IIRC the optimal RPM for the Benders is ~8800 RPM.

From what i've read the Red heelclicker primary spring seems like the ticket, and maybe the green secondary spring.

Seems like most people are running 4.8-6g in the 3-4g in the tip.
That's about where this similarities stop...

I understand that every sled will be a little different, so I am just looking for some starting pointers and also if I should use the 52/40 or 50/40 helix?

Thanks everyone!

 

[Turk]

The Bender shifts out way more aggressive then the dalton & it would be the one to use.. it,s very close to an advantedge(RIP). Start with 4 grams heel/ 3 in tip & green at 70 wrap.
use the red primary spring

 

[YrkViper]

The Bender shifts out way more aggressive then the dalton & it would be the one to use.. it,s very close to an advantedge(RIP). Start with 4 grams heel/ 3 in tip & green at 70 wrap.
use the red primary spring

Will do!

Thanks Turk it is much appreciated!