A couple of bucks
VIP Member
So has anyone ever cut down their 1 inch or 1.187 inch lug track. Possibly looking at getting either one of these and trim my own design. Out of the middle or sides of the scoops that are molded into this track. Mabey leave the full lugs over the slider area and trim the middle-ish area down to flush or 1/2 inch.
I have a Dremel w/ a router attachment. For the 1 inch track...put a 1 inch piece of wood on both sides of the lug and go to town. Same thing for the 1.187 durasport except the blocks on either side of the lug would measure 1.187 inches.
http://www.cbperformanceparts.com/products/?pcid=124#top
http://www.cbperformanceparts.com/products/?pcid=123#top
I have a Dremel w/ a router attachment. For the 1 inch track...put a 1 inch piece of wood on both sides of the lug and go to town. Same thing for the 1.187 durasport except the blocks on either side of the lug would measure 1.187 inches.
http://www.cbperformanceparts.com/products/?pcid=124#top
http://www.cbperformanceparts.com/products/?pcid=123#top
Last edited:
tedgoesfast
New member
could i ask why?
A couple of bucks
VIP Member
Wanted something like a Trailsport but it is only .91 . I know the Carve is similar but I am certain the durasport line has a higher durameter.