
bluemonster1
LIFE MEMBER ONLY ONCE!!!



Then read a little more..there is a right way and a wrong way to install the 2 end bearings on the shaft.When they lock into place the the 2 oil holes that extend through the bearing race into the braring rollers must line up with the 2 holes in the case in order to get oil.I didn't know that was an issue at the time,but if I flipped the bearing the wrong way the oil holes will miss the holes in the case..

Who said this would be easy,nothing in the Yamaha manual stating the importance of these 2 situations. I am almost ready to park everything for now and basically give it up and maybe I won't even try the 600 re-build at all..at least have 1 sled running.I knew something was going to go bad here...think I am very depressed right now and will grab the Crown Royal and then go to sleep early tonight.Haven't lost my temper yet..but it is close...
