pipe question

I believe you can as I have run aaen and power inc
700 pipes on a 600 and ran solid. Someone on this site
may have actual specs for you. Jetting and clutching
you will have to aquire from manufacturer or through
your own testing.
 
The Hauck Hushers/Simmons CPR for my sled (1999 SX) will work for both the 600 and 700 sx models. Let me know your email address and I will send you the installation manual which has the setups for both the 600 and the 700 and each. I have a set of these from when Hauck sold the simmons pipe. As such, the instructions came from Hauck, but should get you close. One thing I will say is that with my Big Bore, and the tripple pipes on, it ran very very rich. I am going to try to get them dialed in again this year. I just didn't have the time to get them dialed in the last couple years, but am going to this year! So shoot me your email and I will send you that manual. Thanks!
 
Last edited:
Here is a copy and paste from the install guide, but let me still email you the instructions. Hope this helps!

Hauck Husher Pipes
YAMAHA 600/700SX(R) Triple

===============================================
700sx(r) Stock Motor Jetting
===============================================
#1
Main Jet- 150-150-150
Pilot Jet- STD
Mixture Screw- 1 1/2 turns out
Air Jet-1.2
Needle clip- PTO side: 3rd position,
Center & MAG: 4th position (4th down from top)

===============================================
700sx(r) Ported
===============================================
Sea Level - 2000 ft @ 10 degrees + #2
Main Jet- 155-155-155
Pilot Jet- 47.5
Mixture Screw- 2 turns out
Air Jet-1.0
Needle- Same as #1

===============================================
600sx(r) Stock Motor Jetting
===============================================
Sea Level - 2000 ft @ 10 degrees + #3
Main Jet- 143.8-143.8-143.8
Pilot Jet- STD
Mixture Screw- 2 turns out
Needle- _ _ _
3 4 4

===============================================
600sx(r) Ported
===============================================
Sea Level - 2000 ft @ 10 degrees + #4
Main Jet- 145-147.5-145
Pilot Jet- 47.5
Mixture Screw- 2 1/2 turns out
Needle- Same as #1

===============================================
760 Big Bore Jetting
===============================================
Sea Level - 2000 ft @ 10 degrees + #5
Main Jet- 160-162.5-160
Pilot Jet- 47.5
Mixture Screw- 2 turns out
Needle- Same as #1
*NO PLATE IN AIR BOX

*NOTE: Bored Carbs- the main jets go up 1-2 sizes, everything else the same, you may want to richen needles another 1/2 position if it hesitates.

Simmons CPR Pipes Hauck Hushers 97-99
 
Last edited:
You must log in or register to reply here.


Back
Top