kking32
New member
just bought a nice used camoplast Track studded 144 etc, guy told me it was a 1 inch lug, when i measure the lug on the track it does measures 1 inch, but when i measure the track and lug together it measures 1.25, the studs measure 1.5 total, but only 1.25 stick out. less then half an inch taller then my old stock track on my SRX, will this clear? i know 1.25 is about as tall as you can go without changing a few other things, i also want to add a few more studs and get it up to 192, thanks for any input ,
kking32
New member
studs?
anyone? if the track measures 1.25 lug and track included is this a 1.25 or the lug itself is 1 inch is it a 1 inch? what stud length should i run and will the 1.5 or 1.4 stud clear or will i have to a use 1.25 stud? or what else will work? thanks for any info!!!
anyone? if the track measures 1.25 lug and track included is this a 1.25 or the lug itself is 1 inch is it a 1 inch? what stud length should i run and will the 1.5 or 1.4 stud clear or will i have to a use 1.25 stud? or what else will work? thanks for any info!!!
Agpetro
Member
kking32 said:
I measured my 1.25in track and its 1.25in with the track and lug. So its a 1.25in track you have. For the studs I ran 1.325in and it clears the front heat exchanger by a 1/4in. But you do have to trim your track a good 1/4in where the track windows are,if you dont the track will rub the front heat exchanger and the tunnel protectors.