blueice2001
New member
Hi guys, new SRX member here. I have a stupid question about the gasket between the power valve housing and the cylinder. I ordered all new parts to seal up everthing and new cables because old ones were fraying but I did not notice direction of gasket. If you look close at gasket there is a bevel which makes inside stick up just a little bit, does that go towards cylinder or housing? Maybe it doesnt matter but thought I would ask all the gurus for advice. I am sure I have plenty more questions because last time I worked on one of these was about 15 years ago when my sled didnt have power valves.
I do have 1 more Q, when adjusting valves, I want 2.5mm clearance between cable housing and power valve housing while engine is running, right? Where should I initially set cable before start or just leave loose?
Thanks, blueice
I do have 1 more Q, when adjusting valves, I want 2.5mm clearance between cable housing and power valve housing while engine is running, right? Where should I initially set cable before start or just leave loose?
Thanks, blueice