95rxl650
Member
The short piece that goes from the cup into the driveshaft. I got the piece fished out of the driveshaft and I think I got it out the cup/retainer also, but it looks to me like it only sits in the cup end about 1/8 to 3/16 of an inch.
That doesnt seem right to me, but is this the case?
Thanks
That doesnt seem right to me, but is this the case?
Thanks
You didn't get all of it out. It goes into the speedo housing side about 3/4 of an inch and just about 1/4 inch into the drive axle. I had the same issue and had to buy a new speedo housing. Couldn't get all the wires out.
95rxl650
Member
lol, just asked you about this in the other thread.
Guess I'll try drilling it out and see where that goes.
I pulled about an inch out the shaft.
Guess I'll try drilling it out and see where that goes.
I pulled about an inch out the shaft.