superfan75
New member
I just purchased a Polaris IQ rear suspension this morning and I should have it in about a week or so. I have read that it has the same mounting locations as the Pro X rear suspension, but the front arm should be 7/8" lower than the JB chart. Does the rear arm get mounted 7/8" lowerr too or use the normal recommended location? I've been doing some reading about other members who've installed these in their Vipers. What I want to know is there any advice anyone could give that might make the job go easier or if there is something they might do differently if they had to do it again. I can't wait to get all my work done on my Viper and try it out this winter. Thank you for any insight you'd be willing to share. Especially measurements for mounting locations if someone has found better locations than may be on JB's charts.