Mark Karabelas
New member
I'm a first year viper owner !!!! Bare with me
04 viper s hauck trips the ones that rap around each other v force reeds
Stock primary set up and 47 straight helix and the mag. Burnt up scored piston and jug
It would spin 9100 at wot for a min then fall back to 7500
Don't know if this could be a symptom of why it burnt down no hole in the cente of
The piston tho
I'm gonna get a rod not sure the best is spi or wiesco or something else
And get the damn crank built and a jug now time for some insurance
Can't get a jet chart for these dang pipes and a head cut or just an
Opticool gasket and srx base gaskets idk
Help!!!!!!!
04 viper s hauck trips the ones that rap around each other v force reeds
Stock primary set up and 47 straight helix and the mag. Burnt up scored piston and jug
It would spin 9100 at wot for a min then fall back to 7500
Don't know if this could be a symptom of why it burnt down no hole in the cente of
The piston tho
I'm gonna get a rod not sure the best is spi or wiesco or something else
And get the damn crank built and a jug now time for some insurance
Can't get a jet chart for these dang pipes and a head cut or just an
Opticool gasket and srx base gaskets idk
Help!!!!!!!
u will need to put some picture .....I would go with spi before wiseco ....u will need to give more about jetting needle pilot ...so people could help u
YAMMIEGOD3:16
Active member
those are cpr pipes. find the correct jetting spec here. 3:16 (yammie tony)
Mark Karabelas
New member
Yup as soon as it's not freezing in my garage I will pull it all out and
Show pics and carb settings I bought it with these pipes and didn't know
Enough about this motor to check all the set up in carbs but every pic
I see of a used head that mag dome looks much leaner and hotter than
The other two so that says something to me but not sure what lol
Show pics and carb settings I bought it with these pipes and didn't know
Enough about this motor to check all the set up in carbs but every pic
I see of a used head that mag dome looks much leaner and hotter than
The other two so that says something to me but not sure what lol
Mark Karabelas
New member
Here on Ty ?
snoprokidf6
Member
I'd be interested in this jetting chart for CPR pipes as well.
YAMMIEGOD3:16
Active member
no, there was just a post on here about these pipes and jetting. couple pages back. 3:16 (yammie tony)