Got my carbs apart (top and bottom covers off) to re-jet, found 125 mains in it so am replacing with 140,141's, but not sure where to locate the shims and clip to adjust the needle height?
Please help trying to get out tomorrow morning!!!
Please help trying to get out tomorrow morning!!!
karlburns
New member
If you didn't already figure it out on the very top theres two small hex screws down below the arm on top of the carb. Take the 4 screws off the face of the carb, stand it straight up then take out those two hex screws. This will allow you to flip the metal piece holding the needles in place up. From there its just a matter of wiggling the front of the carb off and then pulling the needle up.
I've still got my carbs sitting in my living room floor if you have any questions let me know and I can post up a few photos.
I've still got my carbs sitting in my living room floor if you have any questions let me know and I can post up a few photos.