ive got a viper motor with around 5ooo miles on it, but its been sitting for a few years. was going to rering it but got to thinking ( I know, all you do is get in trouble) should I get the crank checked and install new crank seals? is it a lot of work to split the case? what do you use to seal the case? thanks guys , learn a lot from this site
viper engine
- Thread starter bobsiding
- Start date
how was it stored? Crank seals last a long time!
03viperguy
Moderator
How long is a few years? How was it stored and where?
Sent from my XT1254 using Tapatalk
Sent from my XT1254 using Tapatalk
I would tear it down, check all the bearings and rods, replace seals. It is cheap to inspect.
03viperguy
Moderator
I'm in agreement. Plan on doing it with the three 2 strokes we have that have been sitting for a few years unused. Take out the motor, flip it and split the cases
Sent from my XT1254 using Tapatalk
Sent from my XT1254 using Tapatalk
Youllbe2nd
New member
Yep...if motor is out its not a big job
Sent from my E6560C using Tapatalk
Sent from my E6560C using Tapatalk