xsivhp
Active member
Thanks for the replies ... I'm still trying to get this together for a ride this weekend. Ran to Hauck today and got some parts - running back tomorrow to get the rest.
Got new seals, a lower bushing, o-rings, reeds, air filter foam, exhaust donut, Speedo brg, throttle cable, track, rebuilt the ohlins, rebuilt the skid shocks in the M10 and cleaned the carbs ... hopefully I can get her back together and she runs good!
Got new seals, a lower bushing, o-rings, reeds, air filter foam, exhaust donut, Speedo brg, throttle cable, track, rebuilt the ohlins, rebuilt the skid shocks in the M10 and cleaned the carbs ... hopefully I can get her back together and she runs good!
Geez!
You made it sound like you were on a budget! Lol
You made it sound like you were on a budget! Lol
If you get friendly with the local muffler shop, they will let you match exhaust donuts up with the wall of them, I got 3 new ones for slp pipes, cost me $10
A couple of bucks
VIP Member
Put a layer of exhaust RTV on that donut before securing the pipe to it. Makes for a great seal. A leak at the donut affects performance.
A couple of bucks
VIP Member
My local Midas shop owner graduated high school a few years ahead of me. I just took in my chewed & regeratated(ha-ha) donut in and he let me go thru his selection to find the exact one.If you get friendly with the local muffler shop, they will let you match exhaust donuts up with the wall of them, I got 3 new ones for slp pipes, cost me $10
Lol j/k...
A couple of bucks
VIP Member
I know right!!!! Those donuts were all the way up high in the Garage area of the shop on a pegboard. He had a 10-15' stick w/ a nail thru the end to pick out the one you needed. Old school.
xsivhp
Active member
Isn't that how it starts?
LOL - I knew there would be plenty more to spend $ on. Figure since I have it apart and don't have time to do it again I should replace bearings and such.Sent from my Pixel 2 using Tapatalk
xsivhp
Active member
Well I got the sled up and running. It needed quite a bit more love ($$$) than I had thought but hopefully we can get some use out of it now.
Cleaned carbs, new reeds, throttle cable, y-pipe donut, chain case and drive shaft bearings, new ripsaw track and a BFN M-10 suspension too!
Cleaned carbs, new reeds, throttle cable, y-pipe donut, chain case and drive shaft bearings, new ripsaw track and a BFN M-10 suspension too!
