Need help with SX700 Driveshaft bearing replacement

[sloTJ]

I have my whole sled torn apart and doing driveshaft bearings. I picked up a “All Balls” driveshaft bearing kit and basically don’t know where some collars belong, the o-rings and what order this all goes back together. I have a skinnier and a wider collar that I think fell down after removing the back half of the chaincase. Where do each of these go?
There are two additional collars on both the jackshaft and driveshaft that I left untouched.
Please look at these pictures and let me know where these collars and o-rings belong.
Thank you so much!

 

[MURDER YAMAHA]

https://www.yamahapartshouse.com/oemparts/a/yam/5003bb0ff8700212fc83fa1b/track-drive-2

 

[sloTJ]

Thanks and I did look at the microfische and it honestly confuses me further...

 

[MURDER YAMAHA]

The parts you have in your hand are 20 and 32.
They go on right behind the gears, bigger one on top, smaller on bottom.

 

[sloTJ]

The parts you have in your hand are 20 and 32.
They go on right behind the gears, bigger one on top, smaller on bottom.

Thanks, I have it all togther but had larger on bottom, small on top so ill have to swap those!

 

[MURDER YAMAHA]

You will see that if it isn’t correct, the chain won’t be straight, as the gear spacing will be wrong. May even rub on the cover.