Suspension swap

M

mikerx

Member
Joined
Jul 8, 2008
Messages
52
Age
53
Location
Kitchener, Ontario
Hey guys I just picked up an SC3 out of an 04 Rev. I’m putting it into my 04 Viper. I’m just looking for the measurements to drill the new holes. And also if it will Line up with the front holes on the viper tunnel. Thanks for any info!
 
Have you tried the search function?

fourbarrel

Thread 'SC10 2 into SRX'

I have an SC10 2 from an MXZ chassis and am about to tackle the project of grafting it into my SRX and luckily my bud has an MXZ 800X to take the hole measurements from.What I would like to know is will I need drop brackets for the rear mount location or is the proaction tunnel deep enough to drill the new hole without getting into location issues.I briefly looked at my buds sled the other day but didn't have a tape measure with me so I don't know right off what I'm in for.Has anyone else done this before that could answer this for me?
 
MrSled said:
Have you tried the search function?

fourbarrel

Thread 'SC10 2 into SRX'

I have an SC10 2 from an MXZ chassis and am about to tackle the project of grafting it into my SRX and luckily my bud has an MXZ 800X to take the hole measurements from.What I would like to know is will I need drop brackets for the rear mount location or is the proaction tunnel deep enough to drill the new hole without getting into location issues.I briefly looked at my buds sled the other day but didn't have a tape measure with me so I don't know right off what I'm in for.Has anyone else done this before that could answer this for me?
Click to expand...
I have. I’ve found nothing specific for an 04 sc3 with front tabs going into an 04 viper. Especially where to put the front holes. Lots of stuff on SRX swap. If you could point me in the right direction that would be great
 
mikerx said:
I have. I’ve found nothing specific for an 04 sc3 with front tabs going into an 04 viper. Especially where to put the front holes. Lots of stuff on SRX swap. If you could point me in the right direction that would be great
Click to expand...
Read that thread I posted. The dimensions are the same to mount in a SRX as well as any pro-action sled.
 
You must log in or register to reply here.


Back
Top