Dragster powered with Yamaha 700 snowmobile engine.

[hardcor70]

I have been building a rear engine dragster powered with a 700 c.c. SXviper out of an '02 sled. Most everything is done but I have reached the point were I need to start assembling the wiring. Before I removed the engine and clutch I marked all the wires so I could tell what went where. I do not need the wires for headlights, taillights, hand and thumb warmers. I would also like to get rid of the fuel and oil tank sending unit /level wiring. My question is how do I go about doing that? I read that resistors should be used when deleting some of the electrical components but not sure how to go about it. Any info would be helpful. Thank you.