Need Some Help Fast!!

[auji700triple]

Takin My Cylinders off, i can't get the Power Valves Off the motor, i got 6 screws off and the rest are Way to tight for anyhing! i trtied everyitng and wat happened. Striped out the ****in holes.. AHHH ****!!!! Can anyone Help Me > this is starting to annoy the **** outa me! and its pissing me off Bad! cylinders needs to be sent out tommorw and this happens.. aWat do i do/?!?!?!?!?!?!??!!!

 

[sxviper32]

you can drill out the center of them and pound a flat screw driver in, not too hard but just to get a bite, and try to screw them out.

 

[maxdlx]

Use a cordlessdrill, and set it to a soft level, and let it rattle. It will break them loose. Maxdlx

 

[Ding]

Vice grips will usually get them out. Don't put the bad ones back in next time or they will be even harder to get out. I usually plan on replacing them every fourth or fifth time out.

 

[Viper_Dave]

Ditto on the vice grips. My second cleaning was a little later ( like 3,000 miles later) than it should have been. Had 4 that wouldn't budge. Ended up stripping out the socket head of the screw. Grabbed a vicegrip and ....PRESTO!! When I reinstalled ALL new screws, they were coated with high temp anti-sieze. No more problems!! And I do my cleanings a little more frequently as well, LOL. Good luck .

Dave

 

[auji700triple]

thanks guys for the fast replys!!

 

[mdkuni]

I just had the same thing with one of my screws for the power valves. I took a cordless drill and drilled a notch on the top of the screw. I then put a flat screwdriver in the notch and tapped it with a hammer. It worked like a charm. Especially when you don't have any vise grips. Probably won't work to well if it is one of the bottom screws.