sledlife
New member
I have just ordered a new 121X15 X 1.5" RIPSAW to replace my existing 121X1" Challenger Track. on My 97 VMAX XTC 600.
Do I need to get smaller Drive/Track Sprockets for the track to fit?
Will I have the clearence with the new lug Height without doing any mods?
Do I need to get smaller Drive/Track Sprockets for the track to fit?
Will I have the clearence with the new lug Height without doing any mods?
yamaholic22
Active member
to run this with 9 tooth drivers you will have to remove the tunnel and heat exchanger protectors if you have them. If you want to stud it you will have to go to 8 tooth drivers.