Anyone Try 8' Rear Wheels On A 121' Proaction?? [viper]
I have them on my 121 05 RX1....look awesome....see the My Sled in the Sled Garage
Tom, Who's Kit Is That???
Thats the Performance Engineering Kit...I think Rich may have a few..
richierich
New member
yep i do.have billet and plastic wheels also.
offset kit=$110
plastic wheels=$20 each
billet=$95-125 depending on style
offset kit=$110
plastic wheels=$20 each
billet=$95-125 depending on style
Rich, P.m. Me Your #
Last edited:
richierich
New member
920-582-4823 or you can always find it on my site.thanks
monker
New member
sxviper32
New member
mr sled and monker, did you guys gain back the 7 of so mph with the big wheels? thanks!!!
Not sure...but I too have them on my M10 136...
monker
New member
7 or so mph? I assume you are refering to loosing top end when putting in a m10? If that is the case, I put the 8" wheels on at the same time as I put the suspension in. I did not see any loss of top end.
Waterfoul
New member
8' wheels? Monster truck suspension?
richierich
New member
yep its the new fad forget about tiny 8" wheels 
I was successful at resisting the urge to make a snide comment earlier about the 8-foot wheels, but now I see others have succumb to the temptation. That sled must be a handful to corner with, but I bet it goes over most anything . . . he he he
monker
New member
considering it's a 121' suspension, it can't be that bad. All the proportions are still the same with the 8' wheels. (121 foot with 8 foot wheels and 121 inch with 8 inch wheels)
ALL RIGHT GUYS!!! I MESSED UP. 
Wonder what kinda gas mileage that thing gets . . .
Sorry, I'll lay off now. I just enjoy these somewhat humorous posts. They help break the doom and gloom of work.
Hope you are laughing with us, it's all good . . .
Sorry, I'll lay off now. I just enjoy these somewhat humorous posts. They help break the doom and gloom of work.
Hope you are laughing with us, it's all good . . .
vipertripplexxx
New member
If you do get aluminums, don't get the ones with rubber on them. The rubber started comming off in under 600 miles. I have the preformance engineering wheels, and they said they would re-ruber them for ten bucks, to bad they are out of buisness. Well it seems like thats the case, cause they still have a website, but none of the phone numbers have worked for months now.
They are back, but I'm not sure I would want to send too much money their way just yet. Snoop around on Snowest to hear 1st hand, a lot of people lost a bunch of $ when they went under (those hyper-lites aren't cheap). I ordered a PEM offset axle more than a week ago from a 3rd party vender who was promised the axle this past monday, been 5 days and they have not seen the axle yet from PEM to ship to me. Sounds like they might still be up to their old tricks.....
Waterfoul
New member
Ding said:
I have no will power! LOL!!
